Walnut Blasting Machine
Dry Ice Blasting Machine
Refrigerant Filling MachinesWire
Four Wheel Aligner
Digital Differential Pressure Gauge
Tire Inflation Tester
Three-Phase AC Potentiometers
Automotive Diagnostic Protocol
Motorbike Diagnostics
Motorbike Instrument Panel
Motorbike Diagnostic Cables
OBD Cable
Wire Lead Set
Walnut Sand
Stanley Bright (store manager) –
Used this on my 2006 Scion tC to bleed the brakes after a master cylinder replacement. Used the wrong adapter at first, then tried the one in my pictures. Pushed all the air right out and flushed the system well.
Alot of Toyota’s use this style master cylinder, so if you’re looking to bleed your brakes solo, grab this unit. No air compressor needed, and about 10psi on the gauge is plenty.
very good
Wade Juliet (store manager) –
Have done two successful flushes on two Toyotas. One a 2009 Camry and a 2010 FJ Cruiser. Has a lot of adaptors to fit most vehicles. My main concern was the non threaded universal one but the Toyota one with the seal and collar works well, no leaks on fluid or air. Brought psi to 30 and bled furthest to closest and was amazed on how simple this method works, you do need a little elbow grease to pump and bleed. There was no instructions but you can follow videos on YouTube. A little advice when you’re done bleeding a caliper unscrew the top from the bottle to release pressure if you just pull the adaptor off the bleed valve then the back pressure from the bottle will shoot old fluid out on to your car or floor. Was able to flush a whole FJ Cruiser system with 1 liter of ATE fluid, new fluid is in the big bottle and old fluid is in the little bottle.