Three Phase Detector Rotary Tester Non-Contact Phase Sequence Tester

$79.00 – $89.00

United States dollar ($) - USD

United States dollar ($) - USD
Euro (€) - EUR
Pound sterling (£) - GBP

1.The difference between 01 and 02

01Added a function “Motor Rotation detection”Non-contact rotating magnetic field Indication
DYXZ-01 can dectect rotation of single phase and three phase motor. But can not detect motors controlled by frequercy converter

2.The common function of 01 and 02 is:

Phase Detection
Live Voltage Detection
Phase missing Detection

More Discounts? Please Contact us Get exclusive offers Here

DY29 This is an automotive tool for the OBDII Diagnostic Link Connector that provides easy access to the OBDII connector for convenient and safe monitoring of protocol, power and ground signals. Once an unconfirmed signal is detected, it can also be connected to a multimeter or oscilloscope for further testing.

Automotive Diagnostic Protocol Tester DY29 Functions

Features

DYXZ-02 non-contact phase rotation tester designs for quick , easy and accurate detection of three phase sequence in motor installation and repair . The non-connection to insulated conductor avoids uncertain and difficult connections to bare high voltage wires
This is a phase detector, designed to perform phase sequence checks and live line checks of a 3-phase circuit using a static induction voltage clip.
The static induction voltage clips are used to be able to clip on a cladded wire.It is small with a CAT 600V safety rating.
Red LED lamps are used to make the indication visible in dimly lit areas.The direction of phase sequence can be checked easily using the LED lamps, which blink in order.
MRCARTOOL offers a 48 month warranty and 7×24 hour friendly customer service to ensure your shopping experience. If you have any questions about Evap Leak Tester, please contact us directly.

online support

Test operation

1. Phase Detection

CAUTION ! HIGH VOLTAGE !

Connection:

1.Connect the three non-contact alligator clips to the three

2.phase power cables.

(2)The symbol or each clip should be placed at the center of each cables.

(3)Press “ON”,lightA,B,C flashes once to power on the tester.

(4)In case the A,B,C are lit up , R is on if positive CW is detected.

1.If in negative CCW, L is on.

2.If one or more of light A,B,C does not light up , it means the relevant phase is open. In this case, R or L does not represent the indication.

(5)Press “OFF” to shut down the tester after use

2.Live Voltage Detection

CAUTION ! HIGH VOLTAGE !

(1)Connect any of the alligator clips to the conductor. If the conductor is powered on (Voltage within 70~600V AC),the relevant light A,B,C should light up.This can quickly determine if the conductor is powered on.

(2)Clips and lights reference table